Orient will attend Electronica 2024 in Munich
Orient will attend Electronica 2024 in Munich
Electronica 2024 is an exhibition organized by Messe Munchen International. Electronica 2024 is opened in Messe Munchen GmbH located in Messegelande 81829, Muchen,Germany. The exhibition began in 1964 and is held every two years. It is one of the largest and most influential professional exhibitions of electronic components in Europe and the world. So far, 29 sessions have been successfully held. The world's major suppliers of components and components for electronic and test systems participated in the exhibition. In 2022, the exhibition covered an area of 150,000 square meters. A total of 2,140 companies from 51 countries and regions around the world participated in the exhibition.
Shenzhen Orient Components Co., Ltd. is a company with long history, established in 1998, the headquarter address is located in Shenzhen City, Guangdong Province, the company has a total of more than 400 people, including Jiangmen factory 50,000 square meters purification workshop, Longgang headquarters 3,000 square meters. ORIENT is the China TOP brand manufacturer of Optocouplers, IR/PD/PT chips, and LED. The R&D team never stop their step of new products. Orient has more than 500P/N now, which are pin to pin compatible with European, American, Japanese and Taiwan brands.
Orient- as the No.1 manufacturer of China domestic optocoupler, is bound to bring our products out of China's door and to the world. We will take our products and technology to the exhibition.Our booth No.:B3.541/1. Time: Nov.12-15. Warmly welcome your visiting, if you also in the Exhibition.
Orient Intelligent IGBT Driver Optocoupler Products Introduction
In the electronic power system, the IGBT drive circuit is a very crucial component. As the interface circuit between the module and the single-chip microcomputer, it needs to convert the signal from the single-chip microcomputer into a drive signal with sufficient power to ensure the safe on and off of the IGBT and provide electrical isolation between the two. In order to ensure that the IGBT is correctly and effectively protected when a system failure occurs, a separate protection circuit needs to be designed for the conventional IGBT drive circuit.
Read MoreOR-MOC30XX Thyristor Optocoupler Product Introduction
Thyristor photocouplers can be isolated for AC load control, provided the load is relatively small (about 50 mA or less). For larger currents (up to a few amps), a SCR photocoupler is combined with a high-power SCR for AC load control. The following diagram shows the basic circuit configuration. Rs and Cs are elements of the buffer circuit that prevent the thyristor photocoupler switch failure by shielding noise, while the varistor absorbs any surge voltage from the power line.
Read MoreOrient transistor optocoupler introduction- Current transfer ratio (CTR) and response time
The Orient transistor optocoupler (ORPC-817) current transfer ratio (CTR) is a parameter similar to the direct current transfer ratio (hFE) of a transistor and is expressed as a percentage indicating the ratio of the output current (IC) to the input current (IF).
Read More